Cold water
Maybe you will find the solution to your problem below.
Lack of water - Open the water tap completely
Water filter blocked - Clean filter
The water hose is pinched - Straighten the water hose
The voltage is too low - Check the voltage on the location
The gun is not depressed - Turn on the machine and push in the gun grip
An extension cord with too small a cross-section has been used - Use an extension cord in accordance with the table in the operating instructions
The machine has not been used for a long time - Contact the nearest service workshop
Lack of power - Check plug and power cord
Fuse blown - Switch on the fuse
Overload protection activates - Check the power supply. Wait a few minutes and try again.
Out of chemical- Fill chemicals
Check that the nozzle head part marked "pressure" is turned towards ÷
The injector/lance is clogged - Clean with clean warm water
The chemical is too viscous - Mix with water
If an extension hose is used - Fit the original hose (max. 20m)
The soap system is blocked - Fill the soap agent tank with lukewarm water (max. 50 ° C) and rinse through the system.
The bypass valve is adjusted too low - Adjusts the pressure on the bypass valve
Dirt in the nozzle - Clean with the supplied nozzle cleaning needle
Worn nozzle - Replace nozzle / lance
Lack of water - Open the water tap completely
Water filter blocked - Clean filter
Air is sucked into the system - Check that all hose connections are free of leakage
Air in the pump - Switch off the machine, use the gun until a steady jet is achieved. Then turn on the machine.
The multitreg nozzle is in the wrong position - Turn the nozzle head towards +
Valves are locked or worn - Replace valves
The bypass valve is adjusted too low - Adjust up
Defective or worn gaskets in the pump, leakage in the pump - Pump must be overhauled