Sign in
Sign in
About Foma Norge Catalogs/price lists Products Contact Online store private
Privacy angle-right Technical Support / Service angle-right Troubleshooting angle-right High pressure washers angle-right Scrubber drier angle-right Central vacuum cleaner angle-right Foma service partners angle-right Nozzle charts angle-right Deletegninger angle-right Terms of purchase angle-right
About Foma Norge angle-right Technical Support / Service angle-right Troubleshooting angle-right Scrubber drier

Scrubber drier

The machine leaves marks on the floor

- Brush or pad is worn

- Brush or pad is too rough, switch to a softer variant

- Brush or pad is not fitted

The main brush does not clean evenly

- The main brush is worn out, replace the main brush

- Pad is worn out, pad holder is in contact with floor

- The brush head is damaged, contact technical support

Battery charger does not work

- Make sure that there is voltage on the battery charger, that the fuses have not blown and that the power reaches the battery. Try charging with another battery charger. If the battery charger does not work, contact technical support and give the serial number of the battery charger.

- Refer to the battery charger instructions for troubleshooting.

- Make sure that the battery charger is set correctly according to the batteries. The operating voltage of the machine is the same as the voltage of the charger (volts). Check that the charger is set to the same type of battery GEL (gel battery), AGM (AGM battery) or ACID (acid) that is in the machine. On chargers with display, this is shown on the display during start-up of the charger. On chargers without a display, a red LED lights up to indicate that the charger is set to acid battery and a green LED lamp for Gel battery.

The machine leaves water or streaks

- The squeegee is worn out, turn or change the squeegee 

- The suction nozzle or suction hose is blocked or clogged

- Suction hose defective or not connected to the suction nozzle

Battery running time too low

- The battery terminals or charging socket are dirty or oxidized.

- New batteries do not deliver 100% of expected capacity, complete 10 charge cycles.

Defective or used batteries, replace batteries.

- (Ride-on machines) The batteries have not been charged due to incorrect connection between charger and machine.

The machine does not stop dispensing water / soap

Defective or dirty solenoid valve.

The suction motor does not start

- Fault in switch / relay

- The fuse has blown / been tripped

- Cable is disconnected.

- Suction motor is defective

The brush does not move

- Lower the brush, press the brush button.

- Charge the batteries.

- (Ride-on machine) The brush button is not activated.

- (Ride-on machine) The fuse has tripped or is defective, defective brush motor.

Contact About Foma Norge Privacy