Hot water
Maybe you will find the solution to your problem below.
- There is very high humidity in the room / area
- Worn oil seals in between pump top and pump housing
- Defective pistons in the pump
- The chemical tap is closed or clogged
- The chemical tank is empty
- Leakage in the chemical circuit, sucks false air
- The bypass valve is adjusted too low
- The thermostat is adjusted too low or defective thermostat
- The fuel filter is dirty or clogged
- The diesel pump is incorrectly adjusted
- Dirty diesel
- Clogged or dirty burner nozzle
- The heating coil has overgrown with limestone
- Diesel does not reach the burner nozzle
- Out of diesel
- Diesel filters or pipes are clogged
- Defective diesel pump
- The solenoid valve of the diesel pump is defective or does not receive a signal (check pressure switches)
- The burner nozzle is clogged or has the wrong spreading pattern
- Ignition transformer is defective
- Spark plugs are sooty or worn
- Fault in waterinlet / inlet connection
- Clogged water filter
- Leakage in the water supply circuit (sucks false air)
- Leakage in the soap / chemistry circuit (sucks false air)
- Inlet valves defective or worn
- The high pressure nozzle is worn or defective
- The bypass valve is adjusted too low
- Defective pressure control on double lance
- Leakage from the pump, defective gaskets
- Water supply is defective or not connected
- Clogged water filter
- Air in the water intake (leakage)
- The valves have fastened
- Clogged high pressure nozzle
- Power supply fault, not connected
- Motor protection has tripped, thermal sensor has tripped or defective fuse
- Low voltage, defective transformer
- Defective contactor
- Total Stop System is activated (activated after 20 minutes, re-set by turning the machine on and off)
- Microleakage control is activated
- Lacking water